Chapter 2: Installing the Monitor
Mounting the Monitor in an Enclosure
PHM/PM User Guide
2-8
Preparing the Power Connector
Prepare the power source for the unit by sliding the positive and negative
wires into the appropriate slots on the power connector as shown in Figure
2-3 : Power Connector.
Figure 2-3: Power Connector
Connect the ground cable from the power connector to an earth ground.
Mounting the Monitor
There are two styles of clamps used to mount the monitor to your
enclosure depending on the display size. Both styles are illustrated in
Figure 2-4 : Mounting the Clamp Diagram below. When mounting the
monitor, note that the 15” monitor uses 8 clamps to mount in its
enclosure, while the 17” monitor uses 12 clamps.
To mount the monitor:
1
Slide the monitor into the cutout from the front.
2
Attach the mounting clamps, with their screws, to the back of the
unit in the spaces provided.
•
If you have a 15” monitor, attach 8 mounting clamps, with their
screws, to the back of the monitor in the spaces provided. Place
2 clamps at the top and bottom of the monitor and 2 on each
side.
•
If you have a 17” monitor, attach 12 mounting clamps, with
their screws, to the back of the monitor in the spaces provided.
Place 3 clamps at the top and bottom of the monitor and 3 on
each side.
The clamps secure to the unit using CTC’s sliding mechanism. Insert
the clamp into the wide end of the slot and slide it to the thin end.
See Figure 2-4 : Mounting the Clamp Diagram on page 2-9.
