Parker MiniKrimp 94C-001-PFD, Техническое руководство

Страница: 9 / 24

3. Apply appropriate thread sealant to
taper pipe thread of 6-2 CTX-S adapter
and screw into pump (2-3 turns) so
that the fitting (male JIC connection) is
facing the direction of the fill cap.
4. Mount the pump 025399 to the right
side of the crimper as shown in the
image to the left using two 1/4” bolt
holes on the top of the crimper. Note
that only the top two bolt holes are
used.
5. Attach the 025349 bent tube
assembly to the two adapters.
The longer of the two ends of
the tube will attach to the
pump. Tighten the nuts of bent tube
to a minimum of 20 ft.-lbs or 2-1/2
Flats from Wrench Resistance.
6. MiniKrimp™ is ready for operation.
Reference the Enerpac pump manual
for operating instructions.
1. (IF APPLICABLE) Relieve pressure
from attached pump. Remove the hand
pump and bent tube assembly from
the body of the crimper. Do not
remove the adapter (6-6 CTX-S) from
the cylinder. This adapter will be used,
with an orientation change, with the
Air Over Hydraulic Pump.
2. Screw (or reorient) the
6-6 CTX-S adapter into the cylinder
port and tighten until the fitting is
facing in the upward direction. Do not
loosen the adapter to reach the correct
orientation as this may cause leakage.
R
efeR to
C
atalog
4300
of the
P
aRkeR
t
ube
f
ittings
D
ivision
foR
D
etail
a
ssembly
i
nstRuCtions
foR the
CtX P
oRt
a
DaPteRs
RefeRenCeD in
s
tePs
2
anD
3.
Assembling the MiniKrimp™
Air Over Hydraulic Pump Upgrade Kit, Part #025411
6