7
4.
Drill the (2) 3/4” holes for the gas hoses.
5. From inside the cabinet, insert the (4) tee nuts into
the (4) mounting holes. See Figure 4.
6. While supporting the front of the cabinet, tap in the
tee nuts with a hammer. Alternately, a C clamp can
be used to squeeze the tee nuts into the cabinet
surface. Be certain to protect the front surface of
the cabinet with a clean piece of wood between the
C clamp and the finished surface.
7. Slide a screw cap onto each of the (4) screws. See
Figure 4.
8. Orient the hose barbs (they turn) perpendicular to
the mounting plate.
9. Align the mounting plate with the (4) holes. The
hose barbs should extend into the cabinet surface.
10. Connect the gas hoses to the hose barbs. See
Section 1.7.
11. Secure the mounting plate with the (4) screws.
12. Tighten the (4) screws and snap the screw caps
over the screw heads.
1.5.2
Surface Mounting the Bag Tee/Scavenging
Control Valve
For surface mounting, the bag tee/scavenging control
valve is supplied assembled to a mounting plate; see
Figure 7. The hose barbs are oriented so that, when
installed, the hoses attach from below.
1. Position the bag tee/scavenging control valve
template at the desired location on the cabinet
surface.
2. Mark the (4) mounting holes.
3.
Using a #20 drill, drill (4) 0.161” mounting holes.
4. From inside the cabinet, insert the (4) tee nuts into
the (4) mounting holes. See Figure 4.
5. While supporting the front of the cabinet, tap in the
tee nuts with a hammer. Alternately, a C clamp can
be used to squeeze the tee nuts into the cabinet
surface. Be certain to protect the front surface of
the cabinet with a clean piece of wood between the
C clamp and the finished surface.
6. Slide a screw cap onto each of the (4) screws. See
Figure 4.
7. Orient the hose barbs (they turn) parallel to the
mounting plate.
8. Align the mounting plate with the (4) holes, and
secure with the (4) screws.
9. Tighten the (4) screws and snap the screw caps
over the screw heads.
10. Connect the gas hoses to the hose barbs. See
Section 1.7.
Mounting the Bag Tee/Scavenging Control Valve Inside
the Cabinet
For mounting inside the cabinet, the bag
tee/scavenging control valve is supplied with a
mounting bracket. Figure 8 illustrates the bag
tee/scavenging control valve installed on the mounting
bracket.
Install the mounting bracket on one of the inside
surfaces (right or left), toward the front of the cabinet.
During use, the bag tee/scavenging control valve is
turned toward the front of the cabinet. For storage, the
bag tee/scavenging control valve is turned toward the
rear of the cabinet.
CAUTION
The mounting bracket must be secured to the
cabinet surface with bolts and nuts. A washer must
be inside each nut. If necessary, strengthen the
cabinet surface with a furring strip running from
front to back.
Do not install the mounting bracket to the inside of
the cabinet door. Daily use will put too much stress
on the door hinges.
1. Position the bracket mounting template at the
desired location inside the cabinet surface.
2. Mark the (2) mounting holes.
Figure 7. Surface Mounting the Bag Tee and
Scavenging Control Valve
