Parker 404XE Series, Руководство по эксплуатации продукта

Страница: 24 / 35

404XE Series Product Manual
24
Parker Hannifin Corporation
EMN Automation - Parker
Irwin, Pennsylvania
Payload Mounting
Payload is mounted to the 404XE using four tapped holes in the carriage. When fastening to the carriage,
take precaution in using screws with no more than 9.5mm of engagement for the 404XE, as to not damage
the positioner. See Chapter 2 for hole sizes and locations.
Accessory transition plates are available to build X - Y configurations with various table combinations. If doing
so, be certain not to exceed the moment load specifications outlined in Chapter 2. See Appendix A for transi-
tion plate drawings and part numbers.
The 404XE positioner also includes two dowel pin locating holes in the carriage to facilitate repeatable instal-
lation of payload. These holes are employed for multi - axis applications with standard dowel pinning (P33 &
P39 option). See Chapter 2 for dowel pin hole size and location.
Use Appropriate Length Bolt
The 404XE design requires proper size bolts to be used when mounting payloads to the carriage.
Excessive length bolts can cause damage or pin the table in position.
Riser Plates
Most of the motors used with the 404XE have a taller profile than the positioner. Thus the motor can interfere
with the positioner mounting surface. To accommodate taller motors, riser plates can be provided to space
the unit above the mounting surface. See Appendix A for riser plate drawings and part numbers.
Toe Clamp Mounting - 404XE
The 404XE positioner is mounted via accessory toe clamps that engage
the bottom slot in the base profile. To properly mount the positioner
along its entire length, toe clamp spacing along the length of the base
profile must be no more that 150mm. With short units (T01 and T02
options), a minimum of four clamps is required. See Chapter 2 for toe
clamp location, and Appendix A for toe clamp drawing and part number.
The 404XE positioner also includes two dowel pin locating holes in the
base to facilitate repeatable installation of the positioner to the mounting
surface. These holes are employed for multi - axis applications with
standard dowel pinning (P33 & P39 option). See Chapter 2 for dowel pin
hole size and location.