Parallax ELEV-8 Y-6, Инструкция по сборке и эксплуатации

Страница: 9 / 32

Step 4: Motor Mount Assembly
In this step, you will attach the Motor Mounts and Motors to the Booms. DO NOT ATTACH THE PROPELLERS TO THE MOTORS YET.
1. Gather the items listed in the diagram on the next page.
2. Attach each Motor (item 1) to a Motor Mount Bottom plate (item 4). Use four 3 mm x 6 mm screws (item 9) for each motor.
3. Use two 3/8” Panhead Screws (item 6) and two Internal Tooth Lock Washers (item 7) to attach two 5/8” Nylon Standoffs (item 8) to one of
the Motor Mount bottom plates. Use two more 3/8” Panhead Screws and Internal Tooth Lock Washers to attach the second Motor Assembly
to the Nylon Standoffs (item 8).
4. One end of each Boom (item 3) has two holes spaced about one inch apart. Slide an
assembled Motor Mount on this end of each Boom so that the motor leads go through the
Boom tube. Holes in the Motor Mount plates will line up with the holes in the Boom.
PRO TIP: Tape together the leads of one motor on the ends, and also put a piece of tape
on the motor itself. Then, after you thread the leads of both motors through the Boom, you
will know which leads go to which motor.
5. Secure the Motor Mount assembly to its Boom with two 1” Pan Head Screws (item 2) and
two Lock Nuts (item 5).
6. Repeat this process for the other two Boom Assemblies.
Copyright © Parallax Inc. ELEV-8 Y-6 Multicopter Kit (#80100) Version 1.0 Page 9 of 31