Parallax ELEV-8 Y-6, Инструкция по сборке и эксплуатации

Страница: 17 / 32

5. Solder all of the ESCs, both 6 inch 12 AWG
wires, and the 3 inch 12 AWG red leads
together. Likewise, solder all of the black
leads together as shown in the picture to the
right.
6. Cut two 1-1/2 inch lengths of ½ inch black
heat shrink. Slip a piece of heat shrink onto
the two solder joints you just made. Ensure
the entire joint is covered by the heat shrink
before you apply heat.
7. Decide how long you want the 12 AWG
power harness leads to be. If you use the
layout shown below, you will be strapping
both batteries together using the strap holes
indicated, and you can trim the leads to
about 4 inches. If you are going to use a
custom layout to accommodate extra
electronics or anything else you may have,
decide how long to make your harness leads
and then trim them. Once the leads are
trimmed, strip 1/8 inch of insulation from the
end of each lead.
8. Locate the packet of gold bullet connectors
and plastic housings. You will need four
male bullet connectors, and two female blue
housings.
9. Solder a bullet connector onto the end of
each 12 AWG lead.
Battery
(+)
Battery
(-)
LED Tape
(-)
LED Tape
(+)
Holes for Velcro
battery straps
Copyright © Parallax Inc. ELEV-8 Y-6 Multicopter Kit (#80100) Version 1.0 Page 17 of 31