Parallax ELEV-8 Y-6, Инструкция по сборке и эксплуатации

Страница: 18 / 32

10. Insert the bullet connectors into the flattened end of the
blue housings. Insert the red leads into the D-shaped
side, which also has a (+) on the housing. Insert the
black leads into the O-shaped side, also marked with a
(-) on the blue housing. It will take some force for the
bullet connectors to click into place.
PRO TIP: Use a flat-head screwdriver to hold the bullet
connector in the blue housing, and then use a hammer
to tap the connector into place. Give the wires a tug to
ensure they are properly seated and will not wiggle free.
11. Reposition the harness onto the chassis. Using a marker or method of your choosing, mark the ESCs so you can easily identify which lead
goes to what motor when we have the chassis completely assembled. Working clockwise from top to bottom, we will label the motors 1-6,
with the front left Boom’s top motor being 1, and the rear Boom’s bottom motor being 6. Ensure you mark each ESC’s body and servo lead
for an easier build later. Refer to the images below for the numbering process.
1 - Top
2 - Bottom 3 - Top
4 - Bottom
5 - Top
6 - Bottom
Copyright © Parallax Inc. ELEV-8 Y-6 Multicopter Kit (#80100) Version 1.0 Page 18 of 31