DISASSEMBLY
Disassemble the
PANELLIFT
®
Drywall Lift
as follows for transport and compact storage.
1. WITH THE OUTRIGGERS FULLY RETRACTED,
REMOVE THE CROSS ARMS BY PRESSING THE SPRING
TAB ON THE BOTTOM AND SLIDING THE CROSS ARM
OUT OF THE TAPERED SOCKET.
3. WITH THE TELESCOPING SECTIONS ALL THE WAY
DOWN, CLOSE THE RETAINING CAP AS SHOWN.
ALWAYS
CLOSE THE TELESCOPING SECTION RETAINING CAP
WHEN TRANSPORTING UNIT. FAILURE TO DO SO WILL
ALLOW THE TELESCOPING SECTIONS TO EXTEND
FREELY, CAUSING SLACK IN THE CHAINS WHICH MAY
JAM THE TELESCOPING SECTIONS.
2. LOCK THE CRADLE TILT LATCH AND LIFT THE
CRADLE OFF OF THE FRAME.
Push
- 9 -
A
B
4. (A) PUSH THE “LOWER LIFT BUTTON IN ORDER
TO MAKE SURE THE LIFT IS FULLY DOWN AND
THAT THERE IS NO PRESSURE IN THE SYSTEM.
(B) DISCONNECT THE QUICK COUPLER BY PULLING
UP ON THE RELEASE SLEEVE.
