Testing
7-4
7914-A2-GB20-00
February 1998
Starting and Ending Loopbacks
To start or end a local loopback test, enter 4 at the Command prompt.
Command
→
4
Local Loopback is Enabled!
Command
→
4
Local Loopback is Disabled!
To start or end a remote loopback test, enter 5 at the Command prompt.
Command
→
5
Remote Loopback is Enabled!
Command
→
5
Remote Loopback is Disabled!
Resetting the Unit
Enter R at the Command prompt to reset the board. This is equivalent to cycling
the power.
Command
→
R
Reset will bring the loop down. Are you sure? (y/n)
Command
→
If “y” is selected, the Main Menu is displayed, the loop goes down, and the Loop
LED blinks until the loop is restored.
Pressing any key other than “y” is interpreted as an “n”.
