Paradyne FrameSaver SLV 9126, Руководство по эксплуатации

Страница: 68 / 210

3. Status and Statistics
3-32
May 2003 9000-A2-GB33-20
Health and Status Messages
The following table describes all possible Health and Status messages.
Table 3-6. Health and Status Messages (1 of 7)
Message What It Indicates
AIS at DSX-1 An Alarm Indication Signal (AIS) is received by the
DSX-1 interface. AIS is an unframed, all ones signal.
AIS at ISDN PRI (Active/Idle)
(ISDN PRI DBM only)
An Alarm Indication Signal (AIS) is received by the
ISDN PRI interface. AIS is an unframed, all ones
signal.
Only appears when a PRI dial backup module (DBM)
is installed.
„
Active – Backup call was in progress.
„
Idle – DBM was in Idle mode.
The ISDN network is transmitting an AIS.
AIS at Network 1 An Alarm Indication Signal (AIS) is received by the
network interface. AIS is an unframed, all ones
signal. Possible reasons include:
„
Upstream iMarc unit is transmitting AIS
(keep-alive signal).
„
The network is transmitting an AIS.
AIS at T3 User, Port n An Alarm Indication Signal (AIS) is being received on
the T3 user port interface.
Auto-Configuration Active Auto-Configuration feature is active, which allows
automatic configuration and cross-connection of
DLCIs as they are reported by the network LMI.
Back-to-Back Mode Active The operating mode has been configured for
back-to-back operation (
Main Menu
→
Control
→
Change Operating Mode) .
The iMarc unit can be connected to another iMarc
unit without a frame relay switch between them.
This feature is useful for product demonstrations or
for a point-to-point configuration using a leased line.
Backup Active Backup has been established and data is flowing
over the alternate DLCI.
Cable Mismatch, Port- n The presence or absence of an adapter cable on
Port
n is inconsistent with the Port Type setting.
COS n DownPath IP_Address ,
interface [DLCI nnnn ]
The class of service associated with the path is
unavailable.
Cross Pair Detection The TX pair and RX pair are reversed on the DDS
network interface. DLCI is not displayed if service
type is PPP.
Clock Out of Range at Network 1 The clock rate detected on the network interface is
not within the range supported by the device.