ACCULINK 3350 E1 NTU
C-12
June 1996
3350-A2-GB20-10
Table C-6
(4 of 4)
General SNMP Configuration Options
Aux IP Adr:
Next Edit Clear Prev
IP Address for the Auxiliary Port. Specifies the IP address needed to access the unit when the auxiliary port is configured
as the SNMP management link. The IP address is only in effect when the Aux Use configuration option is set to SNMP or
Daisy. The auxiliary port only supports the PPP link protocol.
Edit – Allows you to edit and/or display the IP address for the auxiliary port.
Clear – Allows you to clear the IP address for the auxiliary port. The IP address is set to 000.000.000.000.
Aux NetMask:
Next Edit Clear Prev
Subnet Mask for the Auxiliary Port. Specifies the subnet mask needed to access the unit when the auxiliary port is
configured as the SNMP management link. The subnet mask is only in effect when the Aux Use configuration option is
set to SNMP or Daisy.
Edit – Allows you to edit and/or display the subnet mask for the auxiliary port.
Clear – Allows you to clear the subnet mask for the auxiliary port. The subnet mask is set to 000.000.000.000. If the
subnet mask is 000.000.000.000, the IP protocol creates a default subnet mask based on the class of the IP address
(Class A: 255.000.000.000, Class B: 255.255.000.000, or Class C: 255.255.255.000).
Def Netwk: None
Next None Com Aux FDL Prev
Default Network Destination. Specifies the default network destination. This configuration option specifies where the
default network is connected. For example, if the default network is connected to the communication port, you select
Com. If the default network is connected to the far-end 33xx Series device over the FDL, you select FDL. The routing
protocol uses the default network destination to route data that does not have a specific route.
None – No default network destination. Data that cannot be routed is discarded.
Com – The default network destination is the communication port. This selection only appears if the Com Use
configuration option is set to SNMP.
Aux – The default network destination is the auxiliary port. This selection only appears if the Aux Use configuration option
is set to SNMP.
FDL – The default network destination is FDL. This selection only appears if the FDL management link is enabled for
SNMP.
NOTE: If the chosen default network link is disabled or down, data is discarded. Return to this menu and choose another
default network.