Paradyne 12000E, Руководство по интерфейсу командной строки

Страница: 39 / 42

3. CLI Commands
CLI-A2-GB20-00 October 2004
3-23
Logout
Logs users out of the DSLAM management system.
Reset
Resets (reboots) the Micro DSLAM or IP DSLAM interface module(s), clearing
RAM and restoring all port configurations to original default settings. Resetting the
DSLAM does NOT clear NVRAM; system settings will remain as configured. A
system reset takes approximately one [1] minute to complete, after which you will
be required to log back in.
Who
Returns the IP Addresses of all users currently logged on to the management
system through CLI and specifies whether each user is a Superuser or General
User. Also specifies which user, if any, is logged on via a direct connection through
the DSLAM COM port (as opposed to remote connections via Telnet).
ENABLE_TFTP Enables TFTP Server
ENABLE_WEB_SERVER Enables the web server interface (NMS)
FIRMWARE_VERSION Displays the firmware version
FLOOD [UPL, VLN]
GENERAL_PASSWORD You will be prompted for values
INBAND_MANAGEMENT [ON, OFF]
INBAND_MGMT_VLAN_ID [0-4085]
IP_ADDRESS xxx.xxx.xxx.xxx
LOGOUT Logs user out of CLI
PRIORITY [0-7]
RESET
SDSL_LINE_CODING
[GSHDSL, CAP, 2B1Q]
SNMP_READONLY_COMMUNITY You will be prompted for values
SNMP_READWRITE_COMMUNITY You will be prompted for values
SPEED [XXXXk, OFF] where XXXX = speed (in kbps)
SUBNET_MASK xxx.xxx.xxx.xxx
SUPERUSER_PASSWORD You will be prompted for values
SYSTEM_NAME Changes the DSLAM System Name and CLI Prompt
VLAN_RANGE VLAN_RANGE: SHOW=[ALL, 1-10], SET=[1-10]
VLAN_ID: [0-4085]-[0-4085]
WHO Who’s logged on
[system name] ->logout
[system name] ->reset
[system name] ->who