2. COM Port Connection
2-2
October 2004
CLI-A2-GB20-00
2. Connect one end of a straight-through RJ45 to RJ45 Ethernet cable into the
adapter plugged into your PC, and the other end of the cable into the RJ45
COM port of the Micro DSLAM, management card, or Network Extender.
Launching Your Terminal Emulator
Launch the Terminal Emulator on your PC and configure the program settings.
Actual configurations will depend upon the Terminal Emulator model type being
used, though settings should be modeled after the list below; most are standard
defaults. Refer to your Terminal Emulator user manual for further information.
Logging In
Once your Terminal Emulator has been launched, the following information
appears on your screen:
This information is followed by a request for username and, once username has
been entered, a request for password. You must log in as a superuser in order to
make configuration changes.
CLI Prompt
A command prompt will appear once you have logged in. The CLI command
prompt is tied to the DSLAM system name (see
System Name
in Chapter 3,
CLI
Commands
). The default system name is the model name of the device into which
you are logged.
Baud:
9600
Port:
Com 1
Data Bits:
8
Stop Bits:
1
Flow Control:
Software or XON/XOFF
Transmit Delay:
n/a
Parity:
none
Net to Net Technologies
Copyright (C) [year]
[product model name] Version [number] (Boot Prom [number])
System Build Date: [date, time, year]
Mac Address: [address], IP Address: [address]
Username:
superuser
Password:
Password
[system name] ->
Содержание 12000E
Страница 6: ...Contents iv October 2004 CLI A2 GB20 00...
Страница 8: ...About This Guide vi October 2004 CLI A2 GB20 00...
Страница 14: ...1 CLI Overview 1 6 October 2004 CLI A2 GB20 00...
Страница 40: ...3 CLI Commands 3 24 October 2004 CLI A2 GB20 00...
