BTR 2400 – cod. 93109
19
Mount the wheel in the same order illustrated in fig 5 ensure the nut is not too tight.
Tighten the reamer knob. The reamer knob has a safety switch please ensure the
knob is tightened or the motor will not activate.
Caution: Do not allow hands or any other part of the body, or clothing to enter
inside the feeding chambers or discharge chute, while machine is operating.
WARNING FOR USE
•
Before starting the machine, check that the cutting chamber is empty.
•
Motor should be kept clean of debris and other accumulations.
•
Keep all guards and deflectors in good working condition.
•
Stand clear of discharge chute at all times.
•
Do not over reach and keep face and body back from the feed opening.
ISTRUCTION FOR USE
•
Connect the plug to power point.
•
Ensure that the Top Hopper is firmly secured to the main body of the shredder with the
Locking Knob before commencing operation.
•
To start and stop the shredder, depress the On/Off switch located at the rear of the Motor.
Extension flex
Attention! A defective extension flex may cause electric shocks or fire.
Check the flex regularly and carefully for damages. The device must not be
used with a damaged extension flex; damaged flexes must be replaced.
1. Use a proper extension flex. For flex lengths up to 30m a flex type H07RN-F with a diameter of
at least 1.5 mm² must be used. A flex with a diameter that is too small leads to voltage and
performance losses.
2. The extension flex must be kept out of the working area.
3. The state of the extension flex must be checked regularly. Defective flexes must be replaced.
OVERLOAD PROTECTION AND MOTOR CUT-OUT.
