Paoli DP 36 SF EVO, Руководство по эксплуатации и техническому обслуживанию

Страница: 5 / 56

ENGLISH
OPERATING AND MAINTENANCE MANUAL
5
L
Do not use the wheel gun with the screws of
the clutch cover (view figure Fig.1-E ) or the
motor cover ( view figure Fig.1-P ) loose or not
tight enough ( see table Tab. A “Tightening
Torques” ). If not tighten them with a torque
wrench following the tightening sequence
shown ( view figures Fig.2-E and Fig.2-F ).
L
Pay attention to the exhaust coming out
by the wheel gun during operation ( view
figure Fig.2-B ). To avoid compromise the
performance of the wheel gun, not obstructed
in any case these holes of exhaust.
L
Wheel gun intended to be used for
professional use by trained personnel and
equipped with appropriate technical skills.
L
Do not operate the wheel gun without the
prescribed safety devices.
L
The drive shaft of the wheel gun and the
socket fixed to it may continue to rotate for
a short time after the release of the trigger.
L
Verify that the WARNING label ( view figure
Fig.1-W ) is present and legible, otherwise
replace it by applying new one in the original
position.
GENERAL INSTRUCTIONS
L
Always use a wheel gun with the tightening
torque corresponding to the one required
by the application.
L
Please pay attention to your wheel gun version:
⚪ the Fast Left Hand (LH) version loosens nuts
tightened clockwise faster;
⚪ the Fast Right Hand (RH) version loosens
nuts tightened anticlockwise faster;
L
In order not to compromise the functionality
of the rotation reverse shaft, do not unscrew
or loosen never the rotation reverser grub
screw ( view figure Fig.2-C ).
L
The standard adjustment of the force
necessary for the translation of the rotation
reverse shaft, and thus the reverse is
already performed by Dino Paoli s.r.l..
A personalized set of this force is not
possible..
L
The modes for the correct grip intended
for use of the wheel gun is as follows ( view
figure Fig.2-D ):
⚪ right hand grip on the gun body;
⚪
left hand grip on the surface of the clutch
cover.
OPERATING INSTRUCTIONS
Original operating instructions -
The original language of these instructions is English.
L
Before the use, always perform a dynamic
adjustment of the supply air pressure ( view
figure Fig.5 ). Adjust the supply air pressure
on the low pressure gauge turning the
adjusting screw of the air pressure regulator
while keeping the trigger pressed.
L
Do not exceed the maximum supply air
pressure of 14 bar (with wheel gun running).
REGULATION OF
THE AIR PRESSURE
L
Slide the rotation reverse shaft ( see
figure Fig.1-I ) and push the trigger ( view
figure Fig.1-C ). See the figure Fig.4 to
identify the rotation direction of the
square drive.
L
Avoid accidental starting, being careful not
to unwittingly act on the trigger ( view figure
Fig1-C ).
HANDLING