Paoli DP 197 SFE, Руководство по эксплуатации и техническому обслуживанию

Страница: 4 / 64

ENGLISH
OPERATING AND MAINTENANCE MANUAL
4
DESCRIPTION
Portable air impact wrench designed for motorsport
application (Best Practice: GT, Endurance).
LUBRICANT
Hammer mechanism lubrication: Special
grease for Paoli air impact wrench hammer
mechanism.
Air motor lubrication: Very fluid oil for air
tools or Special oil for Paoli air impact wrench
motors.
ENVIRONMENTAL CONDITIONS
Temperature: -5 ° C ÷ + 45 ° C
Storage temperature: 0 ° C ÷ + 40 ° C
Air humidity: <80%
Max Altitude: 2000m from sea level
INTENDED USE
Assembly air tool for threaded fasteners in the
pit stop service.
TECHNICAL DATA
Weight (kg)
4,60
Length (mm)
200
Square drive
1”
Air inlet
3/8” BSP
Supply hose inside diameter
1/2” (13 mm)
Maximum free speed (RPM)
7.900** (at 20 bar)
Max weight recommended
power socket (kg)
0,70
Operating air pressure (bar)
20 (maximum)
Ultimate torque* (Nm)
1.900**
* These performances have been obtained after having tested the wheel gun on a testing-bench, that is on fixed bolts,
which have been tightened for 5 seconds. Please remind that, during the tightening/loosening on a GT or BTCC car’s
wheel hub you lose most of the torque, due to the hub’s spin. Furthermore the performances change depending on the
wheel gun’s operating-time on each nut, reminding that the correct operating-time on one single nut is, on average,
one second.
** DP 197-SFE Unhanded (UH) version: Maximum free speed is 7.500 RPM (at 20 bar) - Ultimate torque is 1.800 Nm.
L
Before any work on the supply system, always
check that the line is depressurized (no air
pressure).
L
It is recommended to use a whip hose
(flexible hose for compressed air with a
minimum length of 46 cm (18 inch)) with a
threaded male to connected to the air inlet of
the wheel gun, and a male quick disconnect
coupling at the other end.
L
Fit a the whip hose to the air pressure regulator
using a specific supply hose.
L
Use a supply pipe of minimum inner
diameter 13 mm (1/2 inch) suitable for its
intended use.
View figure Fig.3.
L
It is allowed to use exclusively on industrial
plants with compressed air.
L
Make use of a supply system that observes
the indicated pressure values (max 10%
over the maximum value indicated) using an
air pressure regulator supplied by a system
observing the current safety standard, and
that it is subjected to regular checks.
L
The components of the supply system must
be designed and constructed in accordance
with the safety requirements contained in
current international standards.
AIR SUPPLY SYSTEM DIAGRAM