ENGLISH
OPERATING AND MAINTENANCE MANUAL
5
TAB. A
TIGHTENING TORQUES
Clutch Cover
M6 Screw
18 Nm
Motor Cover
M5 Screw
10 Nm
Original operating instructions
-
The original language of these instructions is English.
L
Do not use the wheel gun with the screws of
the clutch cover
(view figure Fig.1-E
) or the
motor cover (
view figure Fig.1-P
) loose or not
tight enough (
see table Tab. A “Tightening
Torques”
). If not tighten them with a torque
wrench following the tightening sequence
shown (
view figures Fig.2-E and Fig.2-F
).
L
Pay attention to the exhaust coming out
by the wheel gun during operation (
view
figure Fig.2-B
). To avoid compromise the
performance of the wheel gun, not obstructed
in any case these holes of exhaust.
L
Wheel gun intended to be used for
professional use by trained personnel and
equipped with appropriate technical skills.
L
Do not operate the wheel gun without the
prescribed safety devices.
L
The drive shaft of the wheel gun and the
socket fixed to it may continue to rotate for
a short time after the release of the trigger.
L
Verify that the WARNING label (
view figure
Fig.1-W
) is present and legible, otherwise
replace it by applying new one in the original
position.
GENERAL INSTRUCTIONS
L
Always use a wheel gun with the tightening
torque corresponding to the one required
by the application.
L
Please pay attention to your wheel gun version:
⚪
the Fast Left Hand (LH) version loosens
nuts tightened clockwise faster;
⚪
the Fast Right Hand (RH) version loosens
nuts tightened anticlockwise faster;
⚪
the Unhanded (UH) version loosens at
same speed both the nuts tightened
clockwise and anticlockwise.
L
In order not to compromise the functionality
of the rotation reverse shaft, do not unscrew
or loosen never the rotation reverser grub
screw (
view figure Fig.2-C
).
L
The standard adjustment of the force
necessary for the translation of the
rotation reverse shaft, and thus the
reverse is already performed by Dino
Paoli s.r.l.. A personalized set of this force
is not possible (
view figure Fig.2-C
).
L
The modes for the correct grip intended
for use of the wheel gun is as follows
(view
figure Fig.2-D
):
⚪
right hand grip on the gun body;
⚪
left hand grip on the surface of the hammer
case.
OPERATING INSTRUCTIONS
Содержание DP 197 SFE
Страница 55: ...ATTACHMENTS TECHNICAL CHARTS 55...
Страница 56: ...ATTACHMENTS TECHNICAL CHARTS 56...
Страница 58: ...ATTACHMENTS TECHNICAL CHARTS 58 Fig 4 CLOCKWISE ANTICLOCKWISE...
Страница 63: ......