PANHANS 334|20, Руководство по эксплуатации

Страница: 40 / 47

BA_PH_335-20_EN_07-22.docx
40
13 Troubleshooting
Proceed systematically when searching for the cause of a malfunction. If you are unable to find the fault or to
remedy the malfunction, contact our customer service department.
Phone number: 0049 7571 / 755 - 0
Before you call us, please follow these steps:
• Make a note of the type, machine number and year of production (see nameplate).
•
Keep this operating manual (and any circuit diagrams) to hand.
• Describe the fault to us in detail so that a competent remedy can be found.
Fault Possible Cause Remedy
The cutter block does not start
No voltage

Check power supply
Control fuse defective

Replace fuse
(see wiring diagram)
Main switch defective

Replace main switch
Motor defective

Replace motor
V-belt torn

Replace V-belt
Emergency stop is locked

Unlock emergency stop
Motor no longer brakes
in intended time (10 sec.)
Brake pads are worn

Readjust brake (

14.2)

If necessary, contact
customer service
Cutter block does not run up cleanly V-belt too loose

Retighten the V-belt
(see section

14.3)
Machine planes hollow or pointed
joint, despite correct setting on the
infeed table
The outfeed table
does not match the flying
circle of knives

Readjust outfeed table
(see section

10.3)
The analogue hollow and pointed joint
position on the table does not corre-
spond to the digital display
Adjusting screw for hollow/
pointed joint was adjusted
with digital unit switched off

Synchronise bot s
(see section

10.2.1)
The digital indicator
cannot be set to 0
Device must be calibrated

Recalibrate indicator
(see section

11.2)