BA_PH_335-20_EN_07-22.docx
30
10.3
Adjusting the Outfeed Table
Figure 18: Outfeed table handwheel
When changing the standard TERSA knives, readjustment of the
outfeed table is not necessary!
Only if other cutter types are used and these are re-sharpened, it
may be necessary to adjust the outfeed table via handwheel (
H
).
Clockwise
↻
Dir
upwards
Counterclockwise
↺
Direction
̶
downwards
In the standard model, the delivery table is factory-set exactly to the flying circle of the cutter.
It should only be adjusted if the knives have been set differently (for example, after sharpening)
H
