BA_PH_335-20_EN_07-22.docx
32
10.4.3
Angular Adjustment > 35°
1.
Push the lever (
1
) to the right (the lever disengages) and slide it backward or forward to obtain the neces-
sary follow-up distance. Then release the lever
The lever has a new starting position.
2.
To adjust the angle of the fence, push the lever (1) to the left and hold this position
The stepless locking
of the angle adjustment opens. The angle can be adjusted to the desired position by pushing the lever back
and forth while simultaneously holding it to the left.
3.
Resetting to 0° is done in the same way.
4.
To adjust the lever to another position, push the lever to the right (the lever disengages) and push it back-
wards or forwards and release it at the desired position.
10.4.4
Using the Auxiliary Fence
•
For planing narrow workpieces or for joining work, use the
swivelling auxiliary fence located above the main fence.
•
When not in use, pull the locking bolt (
B
) outwards, swivel the
fence to the upper position (see
Figure 23) and engage the
locking bolt (
B
) back into place.
Figure 23: Auxiliary fence
10.4.5
Push Block & Push Handle
•
When planing short workpieces, use the supplied push block (
Z
)
or a self-made push block in combination with the manual push
handle (
S
) also included in the scope of delivery.
•
See
Figure 24: When not in use, the push block can be stored
in the tool tray under the operating panel. There is also a suita-
ble storage space for the manual push handle on the rear side.
Figure 24: Push block & push handle
B
Z
S
