BA_PH_245-10_EN_13-22.docx
38
14.2.2
Fence Type 216 (Option)
Figure 26: Operating elements Fence Type 216
With the optional fence type 216, the
total and partial fence are manually ad-
justable. For adjustment, the clamping
levers (
3
) and (
6
) are released and the
fence is adjusted via the hand wheel
(
2
). Afterwards the two clamping levers
(
3
) and (
6
) must be re-tightened.
The partial fence can be
adjusted by the adjust-
ing screw (
5
) and read
off on the vernier scale.
To visualise the actual position, the dig-
ital handwheel (
2
) of the total fence is
equipped with a position indicator (de-
tails can be found in section
Pos. Description
Pos. Description
1
Total fence plate (cast iron)
7
Aluminium splinter tabs
2
Total fence handwheel adjustment
8
Clamping
2
star grip for fence plate adjustment
3
Total fence clamping lever
9
Sliding covers for high tools
4
Partial fence plate (cast iron)
10
Knurled screws for tool covers (
9
)
5
Partial fence adjusting screw
2
11
Milling protection & pressure device
6
Partial fence clamping lever
12
Protective hood (unlocking rear left)
14.3
Operating the Fences
The operation is identical for both fences (type 215 and 216). The only difference is that with type 215 (stand-
ard) a separate measuring device (e.g. setting gauge or similar) is required to position the total fence, whereas
with type 216 (optional) the position can be read directly from the digital handwheel.
Information on operating the digital handwheel can be found in section
14.3.1
Fence plate adjustment
Loosen star grip (
8
) and push the fence plate (
1
) to the desired position. Then retighten star grip (
8
). Always adjust
the plates so that they cover as much of the tool as possible without touching it.
14.3.2
Folding up the protective hood
Before the protective hood (
12
) of the fence can be folded up, the
locking bolt (
V
) at the rear left must be unlocked by pulling it out (see
14.3.3
Fit a grooved board or safety rulers
To insert a grooved board or safety rulers, remove the splinter tabs
(
7
), attach the grooved board or safety rulers as fence bridges and
fasten them via the free threaded holes.
Figure 27: Locking bolt of Type 301
2
The two star grips (
8
) as well as the partial fence adjustment screw (
5
) are located on the rear side.
6
1
4
7
10
9
5
8
11
3
12
2
V
