BA_PH_245-10_EN_13-22.docx
37
14.2
Functions and Adjustment of the Milling Fences
Two different fence types are available for the 245|10 tilting spindle moulder:
•
Fence Type 215 (standard)
→
Total fence is manually adjustable via handwheel and partial fence via adjusting screw.
→
A separate measuring device is required to position the total fence (e.g. setting gauge).
→
The fence is equipped with multiplex fence plates.
→
No retrofitting with integral fence plates possible.
•
Fence Type 216 (option)
→
Total fence is manually adjustable via handwheel and partial fence via adjusting screw.
→
The handwheel for the total fence is equipped with a digital, battery-operated position indicator.
→
The fence is equipped with cast iron fence plates and aluminium splinter tabs.
→
The fence type 216 can be retrofitted with integral fence plates if required.
Increased risk of accidents and collisions! The adjustment and setting processes
described below may only be carried out when the milling cutter is stationary!
When milling with manual feed, a tool cover must always be used!
Remove chips and dust from the table top before adjusting the milling fence.
For maintenance of your fence, please refer to section
14.2.1
Fence Type 215 (Standard)
Figure 25: Operating elements Fence Type 215
With type 215, the total and partial
fence are manually adjustable. For ad-
justment, the clamping levers (
3
) and
(
6
) are released and the fence is ad-
justed via the hand wheel (
2
). After-
wards the two clamping levers (
3
) and
(
6
) must be re-tightened.
The partial fence can be
adjusted by the adjust-
ing screw (
5
) and read
off on the vernier scale.
To position the total fence via hand-
wheel, a separate measuring device is
required (e.g. setting gauge or similar).
Pos. Description
Pos. Description
1
Total fence plate (multiplex)
7
Splinter tabs
2
Total fence handwheel adjustment
8
Clamping star grip
1
for fence plate adjustment
3
Total fence clamping lever
9
Sliding covers for high tools
4
Partial fence plate (multiplex)
10
Knurled screws for tool covers (
9
)
5
Partial fence adjusting screw
1
11
Milling protection & pressure device
6
Partial fence clamping lever
12
Protective hood (unlocking rear left)
1
The two star grips (
8
) as well as the partial fence adjustment screw (
5
) are located on the rear side.
2
5
4
8
1
11
6
3
12
7
10
9
