Panduit ATLONA AT-UHD-PRO3-1616M, Руководство пользователя, Страница: 52 / 76

AT-UHD-PRO3-1616M 52
The following shows how to control displays (or other sink devices) which are connected to an HDBaseT receiver.
When a control device is connected to an IR IN port, the IR signal is transmitted over Ethernet cable, from the
associated ZONE OUT port, to the HDBaseT receiver. IR IN ports are “hard wired” to each ZONE OUT port.
For example, IR IN 1 is wired to ZONE OUT 1ED , IR IN 2 is wired to ZONE OUT 2ED , and so on. IR IN ports cannot
be routed independently.
Controlling Display Devices
1. Connect the IR output of the control system to the IR IN ports on the AT-UHD-PRO3-1616M, using the included
4-pin captive screw connector blocks. Refer to Cable Assembly (page 51) for more infomation.
2. Connect an Ethernet cable from the desired ZONE OUT port on the AT-UHD-PRO3-1616M to an HDBaseT
receiver. Note that the IR IN port and the ZONE OUT port numbers must match. For example, in order to send
IR commands over the ZONE OUT 4ED port, the IR port of the control system must be connected to IR IN 4 on
the AT-UHD-PRO3-1616M. This example is illustrated, below.
Advanced Operation
ZONE OUT 4ED
IR IN 4
AT-UHD-PRO3-1616M
AT-UHD-EX-100CE-RX
Control System
Display
AT-UHD-PRO3-16
16M
FCN
CANCEL
EDID
INFO
POWER
ENTER


Automation Control System
HDMI
IR Emitt
er
IR Signal
IMPORTANT: IR IN ports cannot be routed independently. Each IR IN port is associated with a
ZONE OUT port: IR IN 1 > ZONE OUT 1ED , IR IN 2 > ZONE OUT 2ED , and so on.