Panduit Atlona AT-OME-RX31, Руководство по установке

Страница: 11 / 12

11
Installation Guide
AT-OME-RX31
Resetting to Factory-Defaults
To reset the AT-OME-RX31 to factory-default settings, press and hold the RESET button for
approximately 5 seconds. Release the button when the RESET LED indicator begins to flash.
The LED indicator will flash three times to indicate that the reset procedure has completed.
For easy configuration of Atlona devices, AMS 2.0 is available from https://atlona.com/ams for
free. Two options can be used for installation: The free easy-to-install AMS software (AT-AMS-
SW) download or the AMS server hardware (AT-AMS-HW).
Once AMS has been set up:
1. Open a browser on the same network as AMS 2.0 and go to the IP address of AMS 2.0.
View the AMS 2.0 installation instructions on how to find the IP address of the software, if
necessary.
2. Enter the login information on the AMS 2.0 web page, then click the Login button.
3. View the AT-OME-RX31 manual for more information.
AMS 2.0
Web GUI
The AT-OME-RX31 includes a built-in web GUI, which allows easy management and control of all
features. Follow the instructions below to access the web GUI.
1. Set the IP mode of the AT-OME-RX31. Refer to IP Configuration (page 10) for more
information.
2. Connect an Ethernet cable from one of the LAN port on the AT-OME-RX31 to the Local Area
Network (LAN).
3. Connect an HDMI cable from the AT-OME-RX31 to a display, then press the SHOW IP
button on the front panel to display the IP address.
4. Launch a web browser and enter the IP address of the unit.
5. The AT-OME-RX31 Login page will be displayed.
6. Enter the following information on the Login page. Login credentials are case-sensitive.
Login: admin
Password: Atlona
7. Click the Login button.
OMEGA
TM
AT-OME-RX31
FW
3
2
1
PWR
INPUT
IP MODE
RESET LAN SHOW IP
AT-OME-RX31
DC 24V RELAY
COM C2 RX C1 P TX TX RX
1 2
RS-232 TRIGGER I/O
-
+
L R
- -
+ +
OUTPUT INPUT
3 2 1
IP Mode button