7
Installation Guide
AT-OME-RX31
The
RELAY
port allows the control of screens, curtains, and other devices. Use a 48 V DC relay
with no more than 1 A current draw.
When the AT-OME-RX31 is powered-on or rebooted,
C1
and
C2
are set to the Normally Open
(NO) state.
RELAY Connector
1. Use wire strippers to remove a portion of the cable jacket.
2. Remove at least 3/16” (5 mm) of insulation from each of the wires.
3. Insert the wires into correct terminal using the included 3-pin captive screw connector.
4. Attach the 3-pin connector block to the
RELAY
port on the AT-OME-RX31.
C2
COM
C1
C1 COM C2
