AT-HDR-CAT-2
9
4. Connect an Ethernet cable from the
LAN
port to the Local Area Network (LAN). This step will be required in order
to access the built-in web server.
5. Connect an RS-232 or IR cable from the control system to the RS-232/IR ports. Refer to
for more information.
•
MASTER RS-232/IR
Connecting to this port will provide direct control of the AT-HDR-CAT-2. Control can be performed using
either RS-232 or electrical IR.
•
RS-232/IR 1
and
RS-232/IR 2
Each of these ports is associated to the respective
HDBaseT OUT
port. This allows RS-232 pass-through
zone control of a display (sink) device that is connected to a PoE-compatible receiver. Control can be
performed using RS-232 or electrical IR.
6.
Connect an audio output device to the
AUDIO OUT
port. Refer to
Controlling Audio Output (page 22)
for more
information.
7. Connect the included power supply to the
DC 48V
connector and connect the power cord to an available
electrical outlet.
1. Connect an HDMI cable from a source to the
HDMI IN
port.
2. Connect an HDMI cable from the
HDMI OUT
port to a local display.
3. Connect up to two Ethernet cables from the
HDBaseT OUT
ports to compatible PoE-capable receivers. Refer to
the table below for information on maximum cable length and supported resolutions.
Connection Instructions
IMPORTANT:
Stranded or patch cable is not recommended due to performance issues.
Sheilded cables are strongly recommended to minimize signal noise and interference.
Cable
4K/UHD - Feet / Meters
1080p - Feet / Meters
HDMI
15
5
30
10
CAT5e/6
115
35
200
60
CAT6a/7
130
40
230
70
Installation
