AT-HDR-CAT-2
44
HDBT page
Configuration and Management Interfaces
HDBaseT Zone
Click this drop-down list to select the desired HDBaseT output to be tested.
Setting
Description
Output 1
HDBaseT OUT 1
Output 2
HDBaseT OUT 2
Start
Click the
Start
button to begin the HDBaseT testing process. During testing, the button text will change to “Stop”.
Click the
Stop
button to halt the HDBaseT testing process. HDBaseT testing can be performed at any time, while
the unit is powered. Refer to the instructions on this web page for information on how to interpret the Bit Error Rate
(BER) and cable test results.
TX Version
The version of the Valens chip on the transmitter.
RX Version
The version of the Valens chip on the receiver.
TMDS Clock
Displays the pixel clock speed. If no source is connected, then this field will display as “None”.
Cable length (Estimated)
This field indicates the approximate length of the Ethernet cable connected between the HDBaseT port on the
AT-HDR-CAT-2 and the receiver. If the cable length is less than 15 feet, then this value will be displayed as 0 (zero).
Video Quality (Video BER)
The Bit Error Rate (BER). This field displays either PASS or FAIL during a test.
Cable Quality Pair (A, B, C, D)
Each of these fields will display either PASS or FAIL during a test.
HDBaseT Channel Cable Test
