29
28
USER MANUAL
PANDORA MINI V4 CAR SERVICE-SECURITY SYSTEM
Wire №11 (Orange-black) CAN1-L
— wire of digital bus CAN1-Low. It con-
nects to an appropriate CAN-Low wire of a car.
Wire №12 (Yellow-black) 200mA (-) CH5/CAN2-L
— wire of digital bus CAN2-
Low. It connects to an appropriate CAN2-Low wire of a car. This channel can be
assigned as an output, it will not work as a digital bus in this case.
Wire №13 (Blue-black) 200mA (-) CH7
— Factory setting is “Turn lights”. This
wire connects to a hazard flashers button of a car.
Wire №14 (Yellow) (+) INP2
— Factory setting is ”Ignition” input. This wire
connects to an appropriate wire where 12V voltage appears when ignition is
switched on. If there is no ignition status in a CAN-bus, this input must be con-
nected.
Wire №15 (Purple) 2А (+) CH8
— Factory setting is “Siren”. It connects to a
siren control wire (+).
Wire №16 (Red) (+)
— power supply of the system “+12V”. It must be con-
nected to a reliable conductor with constant voltage of 12V.
SYSTEM CONFIGURATION AND PROGRAMMING
System settings and parameters can be configured using the Pandora
Specialist application. Some functions can be configured only by the program-
ming menu of the system. It is required to put the system to programming
mode to get access to the settings.
Entering the programming mode
You can enter the programming mode only if the base unit is powered
form USB socket or from an external power supply, the ignition is off, the sys-
tem is disarmed and the Service mode is switched off.
Enter the programming mode by entering the ‘Service PIN-code’ (factory
preset is 1-1-1-1). The PIN-code should be entered using an external or located
on the base unit VALET button. The input is indicated by flashes of an external
or located on the base unit LED indicator.
The system stops to perform control commands while it is in the program-
ming mode.
Note! s
ee
the
“c
oNtRol
oveR
the
system
IN
cAse
of
emeRGeNcy
”
sectIoN
foR
descRIptIoN
of
the
pIN-
code
eNteRING
pRoceduRe
.
Note! I
f
theRe
Is
No
‘s
eRvIce
pIN-
code
’,
you
cAN
eNteR
the
pRoGRAmmING
mode
usING
the
‘s
ecRet
pIN-
code
’
WRItteN
oN
the
oWNeR
’
s
cARd
WARNING! I
t
Is
pRohIbIted
to
eRAse
the
pRotectIve
lAyeR
oN
the
oWNeR
’
s
cARd
.
t
he
INfoRmAtIoN
oN
the
cARd
Is
INteNded
oNly
foR
the
oWNeR
of
the
system
.
Exiting the programming mode
There are several ways to exit the programming mode:
Switch on the ignition
Press and hold the VALET button more than 10 seconds (until a siren sound)
Disconnect power of the base unit (disconnect the main power supply and USB)
The system will reboot programmatically (all changes will be saved) after
exiting programming mode. All ways to exit the programming menu are ac-
companied by sound signals of the siren and light signals of the LED indicator.
The signals indicate the number of recorded control devices
