Pando INOXPAN S.L, Руководство пользователя и инструкция по установке

Страница: 99 / 104

INOXPAN S.L. EN - 99
10. TROUBLSHOOTING
PROBLEM
SOLUTION
The hood turns off by itself. - Make sure that the Last Time function was not active, this function will
turn off the hood completely after a few minutes.
- In the case of remote controlled hoods or hoods prepared for remote
control this can happen exceptionally. As the hood has a receiver which
responds to a recorded code, it could happen that there is a hood
nearby that is controlled with a remote control using the same code and
this could affect your hood. To solve this problem, change the code of
the receiver module, using the process for changing the control code
and synching with your hood. Follow the instructions of your remote
control in the section changing code and synching.
- If the problem is still not solved, contact Pando official technical service.
The hood makes a lot of noise
or vibrates a lot. - Check the conduit installation, as some circumstances can increase the
noise level and vibrations, such as:
•
An exhaust conduit that has been badly sealed and badly secured.
•
A conduit with less diameter than recommended.
•
Bends or narrowing close to the motor outlet.
•
Objects obstructing the natural air outlet of the conduit.
•
Badly installed hood, not all the supports and fasteners supplied have
been used.
• Check the material of the wall or ceiling the hood is attached to,
depending on the type of material, it may not be ideal and could be
the cause or origin of amplified noise and vibrations. In these cases,
it is recommended to dampen or insulate between the hood and the
wall or ceiling, using rubber washers or silent-blocks.
- If the problem is still not solved, contact Pando official technical service
The engine does not work. - Reset as follows:
1.Disconnect the hood from the mains with the electric panel circuit
breaker and wait for 2 minutes before reconnecting.
- In case of a motor outside the hood, check the connections between
the motor and the hood. (This should be done by a Pando official
technical service or a qualified professional)
- If the problem is still not solved, contact Pando official technical service.
Hood does not extract well. - Check that the installation and usage conditions are Ok. Se section 2
in the manual.
The hood creates a lot of
condensation.
- See attached bulletin for possible causes and recommendations. Page
100.
The remote control is not
working well, sometimes it
does not connect, it seems
that it lacks power or range. - Check the battery of the remote control, replace with a new one.
- Check that there are no external elements that could interfere with the
remote control signal, such as wireless devices like electric blinds,
digital weather stations, alarms with frequency inhibitors, wireless
sound or audio systems, etc.
- If the problem c
annot be solved, contact Pando’s official technical
service.