17
2. Press
the
POWER
button on the remote control or the power button on the KTC located in the middle of
the speaker bar on the bottom of the screen.
The power button on the KTC has an indicator light that is red when the KTC is off and blue when on. The
remote control sensor is also located in the KTC’s power button. When using the remote control, point directly
towards the sensor for best response.
WARNING: The first time you power the KTC on, you may receive the following
messages:
‘Proceed with Auto Scan’ or ‘No Signal’
Because the KTC defaults to the TV mode when shipped from the factory,
if you are not
connected to digital cable
, the first time you power the KTC on, the unit may display
‘
Proceed with Auto Scan
’, ‘
No Signal
’, and/or ‘
No Database
’ messages. Press
SOURCE
on the remote control or side panel buttons, use the arrows to highlight
DPF
, and then press
ENTER
. The KTC will now be in the Digital Photo Frame (DPF) mode, and will remain in the
DPF mode until you change the SOURCE at a later time.
‘No Database’
If
you
are connected to digital cable
, and the message ‘
No Database
’ appears, the
KTC may not be receiving a strong enough signal for the current channel to be displayed.
Follow the
Initial Tuner Setup
instructions on page 22 to perform the necessary auto
channel scan.
To use your KTC as a television, proceed to the
TELEVISION SECTION
on page 18.
To use the Digital Photo Frame (DPF) features on your KTC, proceed to the
DPF SECTION
on page 34.
