P&E Microcomputer Systems Cyclone FX Series, Руководство пользователя

Страница: 102 / 149

User Manual For Cyclone LC Programmers 102
9.2.2.2 Trim Related (If supported) Configuration Commands
9.2.2.2.1 :CUSTOMTRIMREF n.nn
Processors: All
Desired internal reference clock frequency for the “PT; Program Trim” command. This frequency
overrides the default internal reference clock frequency. Valid values for “n.nn” depend on the
particular device being programmed. Please refer to the electrical specifications of your device for
valid internal reference frequency clock range.
Where:
n.nn : Frequency in Hertz with two decimal places
9.2.2.3 Information Processing Configuration Commands
9.2.2.3.1 :CLEARSTATUS n
Processors: All
Specifies the amount of time after programming, in milliseconds, before the Success indicator
(LED) will be turned off.
9.2.2.3.2 :DESCRIBEIMAGE string
Processors: All
string This is a string that describes the SAP image. Will overwrite the command-line parameter
“imagecontent” if both are present in the .CFG file.
Example:
:DESCRIBEIMAGE KL25Z128 TEST IMAGE
9.2.2.3.3 :ALLOWOUTOFRANGE n
Processors: All
Sets whether programming will continue when data is out of range.
:ALLOWOUTOFRANGE 1 Allows programming to continue when some data is out of
range (addresses not in module). Out of range data is
ignored.
:ALLOWOUTOFRANGE 0 Requires all programming data to be in range of the module.
Out of range data causes an error on image creation.
9.2.2.4 Image Security Configuration Commands
9.2.2.4.1 :PROGRAMLIMIT n
Processors: All
Sets a limit to the number of devices that the Cyclone may program, until this limit is removed or
reset.
9.2.2.4.2 :DATERANGE mm/dd/yyyy mm/dd/yyyy
Processors: All
Sets a starting date and ending date for Cyclone programming operations. The Cyclone will then
only allow devices to be programmed on or between these two dates, until the date limit is
removed or reset. Dates always refer to the Cyclone’s internal calendar. The character between
the two dates should be a single space. The dates should be listed in chronological order, first to
last.
Example:
:DATERANGE 05/10/2018 05/12/2018 Allows Cyclone programming operations on