Panasonic YC-300BP2YAF, Руководство по эксплуатации

Страница: 14 / 64

Installation
OMCTT5639E09
14
3.5 Peripheral equipment (Optional items)
3.5.1 TIG Welding torch
(1) Special torch (Fingertip joint)
(2) Type-1.8 TIG welding torch
You are required to purchase the torch connection
adapter separately.
(3) When using any TIG welding torch other than those
described in the above items (1) and (2):
You are required to purchase the terminal adapter
(CWC00180: See the figure shown below) and the
control cable assembly (TWX00018: See the upper
right figure) separately. (Quantity: one each)
Air-cooling 200A torch Water-cooling 300A torch
YT-20TS1TAG (4 m) YT-30TSW1TAG (4 m)
YT-20TS1TAH (8 m) YT-30TSW1TAH (8 m)
TIG welding torch
(Non-fingertip joint)
Torch connection adapter
Product number Descriptions (See also Fig.1)
YT-08TS1, YT-088T
YT-12TS1, TP1, YT-128T(P)
YT-15TS1, TP1, YT-158T(P)
YX-151AJ1J1
[Replacement cable clamp]TJM00046
[Control cable assembly]TWX00018
YT-20TS1, YT-208T YX-201AJ1
[Replacement cable clamp]TJM00038
[Control cable assembly]TWX00018
YT-20TSW1
YT-30TSW1,TPW1
YT-208TW,TPW
YT-308TW,TPW
YX-301A J1
[Replacement cable clamp]TJM00041
[Control cable assembly]TWX00018
<Fig. 1 Replacement cable clamp> <Fig.2 Control cable assembly (TWX00018)>
Remove the torch cable clamp, and connect it to the torch
side as shown in the above figure. (The welder side uses a
fingertip joint, and the torch side uses a screw-type clamp.)
Welder side Toch side
Welder side
Torch side
(To gas outlet clamp ）
(To output terminal)
Shown below is the case of the air-cooling torch.
(As for the water-cooling torch, a hose and clamp for
return water shall be used, and connected to the
cooling-water equipment.)
<Fig.3> Terminal adaptor (CWC0018)
300
Cabtire cable: 38 mm
2
Torch side:
Crimp terminal
(For
Ｍ 8, ( φ 8.4), Width: 22 mm)
After its connection to the torch,
make sure to insulate it by tape,
etc.
Welder side:
Fingertip joint
(P3550-2)