26
Pairing
3
Pair the microphone
With the microphone powered on, keep the [REG] button pressed for at least two
seconds to start pairing (the status indicator will blink orange).
If pairing is completed successfully, the status indicator on the microphone will switch
to the normal status according to the remaining battery level (green, orange, or red),
and the [REG] indicator on the paired channel on the wireless receiver / extension
receiver lights green for one second and then goes off.
●
If pairing could not be completed successfully, the status indicator on the
microphone will blink red. In that event, place the microphone as close as possible
to the antenna and try pairing it again. (Pairing may fail if the microphone is too far
away from the antenna or under bad connection conditions.)
SENS L
/H
SET
REG
PTT OFF/ON
INP
UT LE
VEL ME
TER OFF/ON
N/A
1
2
3
4
SET
REG
T OFF/ON
INPUT LEVEL METER OFF/ON
* This illustration shows the WX-ST600P.
Status
indicator
Register button
4
Place the battery cover back on
Place the battery cover back onto the product.
memo
Important
●
While the microphone is in use, the [REG] button of the corresponding
channel on the wireless receiver or extension receiver is disabled. Turn the
currently paired microphone power OFF, then you can pair a different
microphone to the channel that is already in use.
●
The wireless receiver / extension receiver cannot enter pairing mode on
multiple channels simultaneously.
●
When a channel on the wireless receiver / extension receiver is in pairing
mode, all other channels can still be used as normal.
