Connection
Caution:
• Before starting connections, make sure that the power connection (24 V AC power cord or LAN cable) is discon
-
nected. Failure to observe this may cause fire, electric shock, injury, or damage to the product.
• A READILY ACCESSIBLE DISCONNECT DEVICE SHALL BE INCORPORATED TO THE EQUIPMENT POWERED BY
24 V AC POWER SUPPLY.
Coaxial cable
To the monitor used
for adjustment
8P alarm cable (accessory)
To a sensor
To a plug-in power type microphone
To an external powered speaker
To a PoE+ hub, PC, etc.
Output cable for the
monitor used for
adjustment
External I/O cable
Microphone input cable (white)
Audio output cable (black)
LAN cable (category 5e or better)
(BNC)
Network cable with cable coupler
8P alarm cable connector
ALARM IN1/BLACK/WHITE IN (black) (Terminal 1)
GND (brown)
ALARM IN2/ALARM OUT (red) (Terminal 2)
GND (orange)
ALARM IN3/AUX OUT (yellow) (Terminal 3)
GND (light blue or green)
Unused (blue)
Unused (purple)
Power cable
Brown
Blue
Green
GND
To the power supply (24 V AC±15 %, 50 Hz/60 Hz)
IMPORTANT:
• The power supply of 24 V AC shall be insulated against 120 V AC (for U.S. and Canada) or 220 V - 240 V AC (for
Europe and other countries).
• Do not cut or process the network cable since the power is superimposed
when using a PoE+ device for power sup-
ply. Besides, do not put an excessive weight on connected sections.
• The network camera is only intended for a connection to an ethernet or PoE network without routing to the outside
plant.
•
Output cable for the monitor used for adjustment
The video output is set to NTSC in the default settings
of the camera. If you want to change the video output
setting to PAL, refer to the Operating Instructions on
the provided CD-ROM.
• Power cable
Connect the power cable to the 24 V AC power sup-
ply using the 24 V AC power supply connector kit
(accessory).
26
