Panasonic WV-SUD638, Руководство по эксплуатации

Страница: 12 / 212

2.
The washer operates according to the “Pulse width” setting. (
®
page 43)
3.
While wiping according to the “Wiper count” setting (
®
page 43), the camera moves back to its original
position.
Note
•
During washer operations, wiper [Start] and [Stop], pan/tilt/zoom/focus control, Auto mode [Start],
and preset action [Start] cannot be operated.
•
“Washer” can only be selected when “Washer control” is selected for “Relay output” on the
[Basic] tab of the “Basic” page. Refer to page 43 for information on washer settings.
•
When “Continuous:High” or “Continuous:Low” is selected and the [Start] button is clicked, the wiper
will stop after a maximum of 5 minutes from when the [Start] button was clicked.
•
During pan/tilt/zoom controls, [Start] may not be able to be operated for the washer.
•
If the wiper or washer operations are started during auto tracking operations, the wiper may be
detected and tracked.
[AUX] button
These buttons will be displayed only when “Terminal 3” of “Alarm” is set to “AUX output” on the setup menu.
(
®
page 99)
•
[Open] button: The characters “Open” on the button will turn green and the status of the AUX connector
will be open.
•
[Close] button: The characters “Close” on the button will turn green and the status of the AUX
connector will be closed.
Note
•
The names of “AUX”, “Open” and “Close” can be changed. (
®
page 109)
[Multi-screen]
Images from multiple cameras can be displayed on a multi-screen by registering cameras on the setup
menu. (
®
page 17)
[Zoom] button
*2
•
: Click this button to adjust the zoom ratio to the “Wide” side.
•
: Click this button to set the zoom ratio to x1.0.
•
: Click this button to adjust the zoom ratio to the “Tele” side.
Note
•
The [Zoom] button cannot be operated while the washer is operating. Operate the control pad/
buttons after the washer has finished operating.
[Focus] button
*2
•
: Click this button to adjust the focus automatically.
•
: Click this button to adjust the focus to the “Near” side.
•
: Click this button to adjust the focus to the “Far” side.
Note
•
The [Focus] button cannot be operated while the washer is operating. Operate the control pad/
buttons after the washer has finished operating.
•
When shooting the following place or the following subjects, focus may not be adjusted
automatically. Adjust the focus manually.
–
Shiny or strongly reflective subject
–
Subject through the glass with dew or smudge
–
Two subjects whose distances from the camera are different
–
Less contrast subject (e.g. white wall)
–
Horizontal-striped subject such as a window blind
12 Operating Instructions
1 Monitor images on a PC