Panasonic WJ-CU550A, Руководство по эксплуатации

Страница: 75 / 138

-71-
5. Group Sequence (G-SEQ)
This table is used to programme or edit a Group Sequence. A Group Sequence consists of up to 64 steps. Each step can assign
to a maximum of 16 monitors, 16 cameras, each with preset position (if applicable) and AUX 1 and AUX 2 control. There are 8
Group Sequences available in this system.
S e t U p
F 1 : N e x t F 2 : P r e F 3 : D E L F 4 : P o p
P R O G . G - S E Q
G r o u p S e q u e n c e 1
M O N I 0 1
1 0 C A M 1 5 0 9 2 0
0 2 0 3 0 4 0 5 0 6 0 7 0 8 0 9 1 0 1 1 1 2 1 3 1 4 1 5 1 6
U p
0 2 2 0 P R E
A U X 1
. . O n
. . O f f
S t e p S t e p
S t e p 0 1 0 2 s e c D w e l l
A U X 2
To programme or edit a Group Sequence do the following:
Note: Before programming or editing a Group Sequence the Alarm Mode must be in the Off mode first. Follow Alarm Mode Setting
Procedures on page 76.
1. Move the cursor to the 3 position by moving the Joystick Controller. Enter the desired Group Sequence number, 1-8, by press-
ing the Numeric Keys, then press the Set (SET) Key.
2. Confirm the desired step number is indicated, if not, move the cursor to position 4 by moving the Joystick controller, enter the
desired step number, 1-64, by pressing the numeric keys.
3. Move the cursor to the 5 position by moving the Joystick Controller.
Enter the desired Dwell Time, 1-30, by pressing the Numeric Keys.
4. Move the cursor to the 6 position by moving the Joystick Controller.
Enter the desired camera number, 1-128, by pressing the Numeric Keys.
5. Move the cursor to the 7 position by moving the Joystick Controller.
Enter the associated pan / tilt preset address number (if applicable) by pressing the Numeric Keys.
6. Move the cursor to the 8 or 9 position by moving the Joystick Controller. Press the Function (F4) Key to open the Pop Up
Window, select AUX On or Off by moving the Joystick Controller and then pressing the Set (SET) Key to execute the selection.
7. When satisfied with this step, press the Function (F1) Key to select the next step. Repeat the above procedures until the
Group Sequence is completely assembled.
8. Press the Function (F2) Key to back up to the previous step.
9. When satisfied with all of the above steps, press the Escape ( ESC) Key to escape from the programming mode. The cursor
returns to the 3 position.
10. Repeat the above procedures to programme the other Group Sequences.
q w e
r
t
y
u
i
o
5