Others
192
LSQT1158
The remote control does
not function.
≥
Has the button-type battery of the remote control run out?
#
Replace it with a new button-type battery. (
l
112)
The DISC EJECT lever
does not work.
≥
The disc cover will not open unless the unit is powered.
#
Connect a charged battery or AC adaptor.
≥
The DISC EJECT lever does not work when the unit is
connected to the computer. (VDR-D310) (Refer to the operating
instructions for PC connection.)
The disc cannot be read.
≥
Are there fingerprints or dirt on the surface of the disc?
#
If there are fingerprints or dirt on the disc, wipe them off. (
l
119)
A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.
≥
If you set [SETUP]
>
[DISPLAY]
>
[OFF], indications other than
warnings and date indications disappear.
Recording does not start
although power is
supplied to this unit and
the disc or card is
correctly inserted.
≥
Is the DVD-RAM or the DVD-RW (VR format) write-protected?
#
Release the protection. (
l
173) If the DVD-RAM or DVD-RW
(VR format) was protected on another device, release the
protection on the same device.
≥
Has the DVD-RW (Video format) or DVD-R been finalized?
#
After finalizing, the discs become play-only and cannot record. If
you un-finalize a DVD-RW (Video format), it can be used for
recording. (
l
173)
≥
Has the SD card’s write protect switch been set to LOCK?
#
No recording is possible while the write protect switch is set to
LOCK. (
l
118)
≥
Is the memory of the disc or card full?
#
If the disc or card has no more available memory, free up some
memory by deleting unnecessary scenes (
l
162, 169) or use a
new disc or card.
≥
Is the unit set to the video recording mode or picture recording
mode?
#
No recording is possible unless the mode dial is at
or
.
≥
Is the disc cover open?
#
If the cover is open, this unit may not operate normally. Close the
disc cover.
Recording starts but
stops immediately.
The playback picture
breaks up for a moment.
≥
Is the disc scratched or dirty?
#
Clean the disc. (
l
119) If there are scratches on the disc, use a
new disc.
≥
The unit is hot. Follow the messages on the display.
To use the unit again, turn the unit off and leave it for a while.
The unit arbitrarily stops
recording.
≥
Is the AGS function activated?
#
Record in the normal horizontal position or set [AGS] to [OFF].
(
l
137)
Problem
Check points
LSQT1158_EN.book 192 ページ ２００６年１２月２６日 火曜日 午前１０時３０分
