Panasonic VDR-D310GC, Руководство по эксплуатации

Страница: 191 / 204

Others
191
LSQT1158
Troubleshooting
Problem Check points
This unit cannot be
turned on.
≥ Is the battery fully charged?
#
Charge the battery using the AC adaptor. ( l 120)
≥ The battery protection circuit may have operated. Attach the
battery to the AC adaptor for 5 to 10 seconds. If the unit still
cannot be used, the battery is faulty.
≥
Is the LCD monitor opened or the viewfinder extended?
This unit is turned off
automatically.
≥ If you do not use the unit for approximately 5 minutes, the
power is automatically turned off to conserve the battery
charge. To resume recording, turn the power back on.
The power will not turn off automatically when the power save
function (
l 183) is set to [OFF].
This unit does not stay
on long enough.
≥ Is the battery low?
#
If the remaining battery power indication is flashing or the
message “LOW BATTERY.” is displayed, the battery has run
down. Charge the battery. (
l 120)
A clicking sound is heard
when the power is turned
off.
≥ This is the sound of the lens moving and is not a malfunction.
Battery runs down
quickly.
≥ Is the battery fully charged?
#
Charge it with the AC adaptor. ( l 120)
≥ Are you using the battery in an extremely cold place?
#
The battery is affected by ambient temperature. In cold places,
the operating time of the battery becomes shorter.
≥
Has the battery worn out?
# The battery has a limited life. If the operating time is still too short
even after the battery is fully charged, the battery has worn out
and can no longer be used.
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥ The unit cannot be operated unless you open the LCD monitor
or extend the viewfinder.
≥
Press the RESET button. ( l 194) If normal conditions are not
restored yet, remove the battery or AC adaptor, wait about 1
minute and then reconnect the battery or AC adaptor. Then
about 1 minute later, turn on the power again. (Conducting the
above operation when the access lamp is on may destroy the
data on the disc or card.)
The screen has changed
suddenly.
≥
Has the demonstration started?
# If you set [DEMO MODE] to [ON] without inserting a disc or a
card in video recording mode or picture recording mode, the unit
is automatically set to the demonstration mode for introducing its
functions. Normally this should be set to [OFF]. Press the MENU
button, then select [SETUP]
#
[DEMO MODE]
#
[OFF] and
press the joystick.
LSQT1158_EN.book 191 ページ ２００６年１２月２６日 火曜日 午前１０時３０分