Panasonic U-16GE2E5, Замена основных компонентов

Страница: 3 / 92

Starter Replacement Procedure
1. Required parts and tools used ...........................................................................21
2. Preparation for work ............................................................................................21
3. Remove starter .....................................................................................................21
4. Install starter .........................................................................................................21
5. Preparation for operation ....................................................................................21
6. Final check ............................................................................................................21
Ignition Electrical Parts Inspection and Maintenance
1. Required parts and tools used .......................................................................... 22
2. Preparation for work ........................................................................................... 22
3. Ignition coils (with built-in power transistors).................................................. 22
4. Crank angle sensor (Figure 2) ............................................................................ 22
5. Cam angle sensor ............................................................................................... 23
6. Spark plugs .......................................................................................................... 23
7. Preparation for operation ................................................................................... 24
8. Final check ........................................................................................................... 24
Ignition Timing Check and Adjustment
1. Preparation for work ........................................................................................... 25
2. Distributor mode setting .................................................................................... 25
3. Start test operation and set engine rotational speed ...................................... 26
4. Ignition timing check .......................................................................................... 27
5. Correction for distorted amount ........................................................................ 28
6. Cancel settings .....................................................................................................31
7. Stop test run .........................................................................................................32
8. Final check ............................................................................................................32
Front Oil Seal Replacement Procedure
1. Required parts and tools used .......................................................................... 33
2. Preparation for work ........................................................................................... 33
3. Remove compressor drive belt. ......................................................................... 33
4. Remove the crank pulley .................................................................................... 33
5. Remove front cover oil seal (Figure 2) ............................................................... 33
6. Install the front cover oil seal (Figure 3) ............................................................ 34
7. Install the crank pulley. ....................................................................................... 34
8. Install the compressor drive belt. ...................................................................... 34
9. Preparation for operation ................................................................................... 34
10. Final check ........................................................................................................... 35
Rear Oil Seal Replacement Procedure
1. Required parts and tools used .......................................................................... 36
2. Preparation for work ........................................................................................... 36
3. Remove the
À
ywheel ........................................................................................... 36
4. Remove the oil seal ............................................................................................. 36
5. Oil seal installation ...............................................................................................37
6. Preparation for operation ....................................................................................37
7. Final check ............................................................................................................37
GHP̲Main̲Parts̲Replacement̲toc.i2 2 2012/07/31 17:54:03