Panasonic U-100PEY1E5, Технические данные и руководство по обслуживанию

Страница: 729 / 739

8-25
8
When using a separately installed receiver as an exposed model, attach it to a wall where the receiver
can be affixed.
(1) Put a slotted screwdriver or the like into the groove on the bottom of the receiver unit and twist it to remove the
bottom of the case. (Fig. 8-25)
(2) To enable the receiver’s wiring to stick out from the upper part of the case (thin part at center-top), use side-cutters
or the like to cut a hole in the case big enough for the remote control cord (sold separately). (Fig. 8-26)
(3) Disconnect the wires that were connected at shipment from the connector.
(4) After installing the remote control cord (sold separately) at the position in Fig. 8-27 with the enclosed cable tie,
connect it to the connector on the receiver.
(5) Shape the remote control cord at the top of the PCB so it fits inside the receiver and after configuring the wiring
like it is in Fig. 8-28, attach the lower case. When doing this, arrange the head of the cable tie so it face sideways.
(6)
(7)
(8)
Remove the face plate and use the wood screws (2) to install the receiver unit.
Use the cord clip that comes enclosed with the remote control cord to fasten it to the wall.
Attach the face plate.
Fig. 8-26
Fig. 8-28 Fig. 8-27
Fig. 8-25
Outlet in the upper part of the
case for the remote control cord
Cable tie (Enclosed)
Connector
Remote Control Cord
(Sold Separately)
About 2 to 3 mm
Remote Control Cord (Sold
Separately)
Cable tie
(Enclosed)
Wood screws
(2)
Receiver Unit
Sec8.indd 25 2012/02/28 16:14:02 SM830211-07̲PAC-i.indb 25 SM830211-07̲PAC-i.indb 25 2013/09/17 23:03:37 2013/09/17 23:03:37