Panasonic U-100PEY1E5, Технические данные и руководство по обслуживанию

Страница: 401 / 739

1
1-391
Fig. 2-8
Do not use natural drainage.
Do not install the pipe with an upward slant from the
connection port. This will cause the drain water to flow
backward and leak when the unit is not operating.
(Fig. 2-9)
Fig. 2-9
Do not apply force to the piping on the unit side when
connecting the drain pipe. The pipe should not be
allowed to hang unsupported from its connection to the
unit. Fasten the pipe to a wall, frame, or other support as
close to the unit as possible. (Fig. 2-10)
Support
bracket
Fig. 2-10
Provide insulation for any pipes that are run indoors.
Checking the Drainage
After wiring and drain piping are completed, use the following
procedure to check that the water will drain smoothly. For this,
prepare a bucket and wiping cloth to catch and wipe up spilled
water.
(1) Connect power to the power terminal board (R, S
terminals) inside the electrical component box.
(2) Slowly pour about 500 cc of water into the drain pan to
check drainage. (Fig. 2-11)
Water drain
Over
100 mm
Plastic container
for water intake
Water
(Approx. 500 cc)
Drain pan outlet
Fig. 2-11
(3) Short the check pin (CHK) on the indoor control board and
operate the drain pump. Check the water flow through the
transparent drain pipe and see if there is any leakage.
(4) When the check of drainage is complete, open the check
pin (CHK) and remount the tube cover.
CAUTION
Be careful since the fan will start when you short the pin on
the indoor control board.
300 mm or less
850 mm or less
* Length of supplied drain hose = 140 mm
0 - 45°
Uphill slope
(4-Way Cassette 60 × 60)
Part Name Figure Q'ty Remarks
Washer 8
For temporarily
suspending indoor
unit from ceiling
Flare
insulation T3
T5 2
set
For gas / liquid
tube connection
Insulation tie 2
For gas / liquid
tube / flare nut
connection
Vinyl tie 8
For flare /
drain insulating
connection
Drain hose
insulation
T10
1
For drain tube
connection
Full-scale
installation
diagram
1
Printed on
container box
Washer head
screw
4
For full-scale
installation diagram
Drain hose
L140
1
For unit & PVC
tube connection
Hose band 2
For drain hose
connection
Use M10 for suspension bolts.
Field supply for suspension bolts and nuts.
SM830211-07̲PAC-i.indb 391 SM830211-07̲PAC-i.indb 391 2013/09/17 22:48:25 2013/09/17 22:48:25