14
Using the Touchscreen
z
When needed, the above settings can be configured using the following procedure.
A
Click [start] - [Control Panel] - [Printers and Other Hardware] - [Tablet and Pen Settings] - [Pen Options]
.
B
Click [Press and hold] in [Pen Action] and then click [Settings].
C
In [Press and Hold Settings], change the settings and then click [OK].
For more information, refer to “Help” in the bottom right corner of the [Press and Hold Settings]
.
CAUTION
z
When the internal LCD is used alone or with an external display simultaneously, the touchscreen function cannot be
used when the area of either display is set larger than default setting of the display resolution.
z
If a change is made to the display resolution, or the cursor cannot be pointed correctly with the stylus, be sure to per-
form [Calibration]. (
z
When mouse drivers are installed (e.g., Intellimouse), the touchscreen function may not be used.
z
When the operation of panning (only the internal LCD) is performed while the display resolution is set higher than the
resolution of the internal LCD, the touchscreen function will not work properly.
z
Even when only an external display is in use, the cursor will move on the external display if the surface of the internal
LCD is touched when the touchscreen driver is active. Therefore, do not touch the internal LCD when only an external
display is in use.
z
The touchscreen function does not work in the Setup Utility, in the “Full Screen” of [Command Prompt], or in Recover
Pro (
NOTE
z
Do not move the stylus too quickly. If the stylus moves too quickly, the cursor may be unable to follow its movement.
