EN28
Bypass selector mounting part (fi lter and water intake)
Important
Do not use detergents, cleansers, paint thinners, benzine, alcohol or kerosene for cleaning purposes. If, for instance,
a detergent has been used by mistake, wipe the surface with a damp cloth to remove all traces of the detergent.
( Otherwise, the detergent may get mixed in with the water running through the Alkaline Ionizer or the plated parts
may be damaged or peel off or the plastic parts may become damaged, discolored or deformed.)
Use of cleansers may also impair the workings of the outlet pipe and cause trouble.
Do not use brushes or other implements made of metal (since they may leave scratch marks).
Do not use a tool to tighten up the nut (since the nut may be damaged).
1
Loosen the nut, remove the bypass selector,
and take out the fi lter.
Set the bypass selector to
.
Nut
Filter
Gasket
2
Wash the fi lter and water intake.
Filter
Water intake
Clean using a clean toothbrush
or other implement.
3
Install the bypass selector.
Make sure any foreign matter is not attached on the end
of the faucet and gasket inside of the bypass selector.
Install the fi lter without fail.
After installing the bypass selector, run water for
about 5 seconds at the
or
setting.
Tighten up the nut until the bypass selector does not turn.
Make sure the
bypass selector is not
inclined.
Install the parts
in the correct
sequence
Remove
the stain using
a clean cotton
swab, etc.
Bypass
selector
Main spout
Main unit, bypass selector and outlet pipe
Soak a soft cloth in water, wring it out well,
and use it to wipe the units and parts.
When the shower part is dirty, remove the stain using a
clean toothbrush or other similar tools.
When the main
spout is dirty,
remove the
stain using
a clean cotton
swab or
other similar tools.
Maintenance
TK-AS700_En.indb 28
TK-AS700_En.indb 28
2022/06/23 14:07:54
2022/06/23 14:07:54
