EN34
1
Repeat connection and disconnection
of the power plug 2 to 3 times,
and remove the power plug.
Each time the power plug is connected and disconnected,
water comes out from the drain hose for approx. 15 seconds.
2
Disconnect the water supply
hose.
Water supply hose
Hose
fastening
nut
Loosen
with hand
After disconnecting the water supply hose, attach the hose
fastening nut to the original position of the bypass selector
(loss prevention).
3
Stand the main unit,
and remove the cartridge.
(P. EN30)
When the cartridge is removed or is in the removed state, do not
face the main spout up, or tip over or reverse the main unit.
(Water may enter the inside the main unit, resulting in a
malfunction.)
4
Put the tip of the water supply hose at
a position lower than the main unit,
and discharge the water
remaining in the hose.
Water supply hose
Suction Disc
5
Remove the suction disc
fi xing the drain hose, and
attach the cartridge cover to
the original position.
(P. EN30)
6
Loosen the nut,
remove the bypass selector,
and remove the water
inside.
Loosen
with hand
When the joint is diffi
cult to
remove
After tightening the nut fi rmly with
hand, rotate it together with the bypass
selector. Then it can be removed easily.
If it still cannot be removed, use a tool
such as a plier to nip the foam joint, and
remove it.
Adaptor
When using a tool such as a plier, protect
the joint with cloth, etc. not to damage it,
and pay attention to the rotation direction.
Remove water from the main unit with the following steps before moving the product.
Stand the main unit while moving. After removing the water, a small amount of water may remain, so put the
main unit in a bag, etc.
When Moving the Alkaline Ionizer
TK-AS700_En.indb 34
TK-AS700_En.indb 34
2022/06/23 14:08:04
2022/06/23 14:08:04
