EN27
Ho
w to Use
Engli
sh
4
When
disappears and the
water quality signal shows the waveform,
use water.
PiPiPi
At the beginning of daily use, run water
approx. 0.6 liters (approx. 23 seconds)
before using. (P. EN7)
Preparation time may become longer
when purifi ed water or alkaline ion water
is used after use of weak acidic water or
after automatic electrode cleaning.
The color of water quality signal
changes according to the type of
selected water.
Alkaline 4 : Orange
Alkaline 1~3 : Blue
Purifi ed water : Green
Weak Acidic water : Pink
Acidic water : Red
5
After use,
close the faucet.
When using the product continuously
For 10 minutes after Alkaline level 1 to 3 or purifi ed
water is used, the same type of water can be used
with short preparation time. (Water comes out
from the drain hose after 10 minutes.)
After Alkaline level 1 to 3 or purifi ed water is
used, the selected water type is stored until
next use. (To change the setting → P. EN32)
If water types other than those are used,
the product is restored to the state where
Alkaline level 1 to 3 is selected previously.
Water may come out slightly from the main
spout even after the water fl ow is stopped. It
is not a malfunction. (This is water remaining
in the outlet pipe.)
When the screen in step 5 is displayed or the
following screen is displayed while water is fl owing
Those screens are displayed when the faucet is not opened
enough or the amount of water fl ow is decreased due to
change in water pressure. (For alkaline ion water, weak acidic
water, and acidic water, electrolysis is stopped.) Increase the
amount of water fl ow slowly, and adjust the fl ow rate.
When a buzzer beeps for approx.
3 seconds, and
is displayed
(P. EN31)
When a buzzer beeps continuously
While weak acidic water or acidic water is
used, a warning buzzer beeps continuously.
(To prevent accidental swallowing)
To make the setting with no buzzer (P. EN32)
When the following screen is displayed
( Only when alkaline ion water, weak
acidic water, or acidic water is in use)
This is displayed when a large amount of water is fl owing.
( In this case, it may not be possible to achieve a high
enough pH level.)
Gradually reduce the fl ow from the faucet until
the display is cleared*.
* Alkaline 1~3
Flow of about 5.0 L/minute
Weak Acidic water Flow of about 3.2 L/minute
Alkaline 4
Flow of about 2.2 L/minute
Acidic water
When pH adjustment is set to the “Stronger”
mode,
tends to be displayed.
(P. EN23)
When changing the settings
(P. EN32)
TK-AS700_En.indb 27
TK-AS700_En.indb 27
2022/06/23 14:07:53
2022/06/23 14:07:53