Panasonic TH-37PR10A, Руководство по эксплуатации

Страница: 34 / 52

34
1/2
PC
Off
Standby save Off
Power management Off
Auto power off Off
OSD Language English (UK)
Component/RGB-in select
RGB
Input label
Signal
Power save
Setup
3D Y/C Filter (NTSC)
Colour system
Signal
On
Auto
Cinema reality
Panasonic Auto (4 : 3) Off
4 : 3
[ AV ]
P-NR Off
1/2
PC
Off
Standby save Off
Power management Off
Auto power off
Off
OSD Language English (UK)
Component/RGB-in select
RGB
Input label
Signal
Power save
Setup
1
2
3D Y/C Filter (NTSC)
Colour system
Signal
On
Auto
Cinema reality
Panasonic Auto (4 : 3) Off
4 : 3
[ AV ]
P-NR Off
Cinema reality
P-NR
Signal
Off
Off
[ Component ]
Cinema reality
P-NR
Signal
Off
Off
H-Freq.
V-Freq.
kHz
Hz
33.8
60.0
[ Digital ]
Sync
P-NR
Signal
Auto
H-Freq.
V-Freq.
kHz
Hz
33.8
60.0
[ RGB ]
Cinema reality Off
Off
Setup for Input Signals
Colour system / Panasonic Auto
Select Signal from the “Setup” menu during AV(S Video) input signal. (“Signal
[AV]” menu is displayed.)
Press to select the “Colour system” or
“Panasonic Auto”.
Press to select each functions.
If the picture image becomes unstable:
With the system set on Auto, under conditions of low level or noisy input
signals the image may in rare cases become unstable. Should this occur,
set the system to match the format of the input signal.
Cinema reality / P-NR
Press to select Cinema
reality or P-NR.
Press to set On / Off.
Press to exit from adjust mode.
Cinema reality:
When on, the display attempts to reproduce a more natural interpretation of sources
such as movie pictures, which are recorded at 24 frames per second.
If the picture is not stable, turn the setting to off.
Note:
When On, this setting only affects the following signal input:
• NTSC / PAL signal input during “AV(S Video)” input signal.
• 525i(480i), 625i(575i), 1125(1080) / 60i signal input during “Component” input signal.
P-NR:
Automatically reduces unwanted picture noise.
Note:
P-NR cannot be adjusted while a PC signal is being applied.
Press ACTION ( ) button
Press ACTION ( ) button
Mode Function
Colour system Set the colour system to match the input signal. When selecting “Auto”, the colour system is
automatically selected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed
properly depending on the attached terminal board. To display M.NTSC signal, select
“M.NTSC” in Colour system.
Auto SECAM M.NTSC NTSC PAL
Panasonic Auto
(4 : 3) Set to “4 : 3” to view 4:3 images in an unchanged format when Panasonic Auto is selected.
If you would like to view 4:3 images in Just format, set to “Just”.
Note:
Panasonic Auto does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used.