Video Input Jack,
Monoscope Pattern Signal
Mode :
STOP
Equipment :
Oscilloscope,
NTSC Video Pattern Generator
1. Supply a Monoscope Pattern Signal to the Video Input Jack.
2. Connect the Oscilloscope to TP50 on the CRT C.B.A.
(Use TP47 for GND.)
3. Select SUB BRIGHT and move the shaded area to the value in EVR
adjustment mode.
4. Adjust the FOCUS CONTROL on the Flyback Transformer so that the
center of picture is the sharpest.
5. Turn the SCREEN CONTROL on the Flyback Transformer fully
counterclockwise.
6. Press DISPLAY key (Service Switch) on the remote control for
collapse scan. (Refer to
HOW TO ENTER SERVICE MODE
.)
7. Adjust SUB BRIGHT in EVR adjustment mode so that the level A is 185
VDC±5 VDC.
Fig. E6
8. Turn the SCREEN CONTROL on the Flyback Transformer clockwise
carefully and stop at the point where any color is first observed.
9. In EVR adjustment mode, select the two colors not observed in step 8
from the following control functions (B CUT -OFF, G CUT -OFF, or R
CUT -OFF) and adjust so that the horizontal line becomes white.
For example, if the horizontal line appeared red in step 8, select and
33
Содержание ShowStopper PV-SS2710
