Panasonic S-22KA1E5S, Руководство по обслуживанию

Страница: 195 / 335

195
17.2 Outdoor Local Setting Mode
•
To enter outdoor Local Setting Mode, at Outdoor unit main PCB:
○ Press and hold SELECT and ENTER button simultaneously for 5
seconds until the 3 digit 7 segment displaying “888”
o
Set the digit 1 by 1 starting from left to right by using SELECT to
scroll the number 0~9, and ENTER to confirm the number of the
digit.
Details
Setting Mode Item
0 1 2 3 4 5 6
10 Piping length Setting Short Medium Long - - - -
11 Auto Restart ON OFF - - - - -
12 Power Saving OFF ON - - - - -
13 Indoor / Outdoor Elevation <30m ≥ 30m - - - - -
14 High static pressure OFF ON - - - - -
15 Cool / Soft Dry Mode Thermo Shift 0°C +1°C +2°C +3°C -1°C -2°C -3°C
16 Heat Mode Thermo Shift 0°C +1°C +2°C +4°C -1°C -2°C -4°C
1
CCL RESET - - - - - - -
Details
Action Mode Item
0 1 - - - - -
Allowable operation
20 Air Tight Test OFF ON - - - - - Standby
21 Refrigeration Collection OFF ON - - - - - Standby
22 Vacuuming OFF ON - - - - - Standby
23 Defrost operation OFF ON - - - - - HEAT Mode
24 Pump Down OFF ON - - - - - Prohibited after installation
2
CCL RESET - - - - - - -
17.2.1 Auto Restart Control
•
Auto Restart Function at outdoor main PCB is a setting to enable/disable AC system for auto restart back the
operation when electrical power resume back from interruption.
•
When electrical power on, the outdoor unit will send a signal about the auto restart switch setting to all connected
indoor units.
•
Indoor Units that having Outdoor Address setting same with the Outdoor Unit will be memorized the signal to
EEPROM.
17.2.2 Power Save Control
•
With Power Save ON, the maximum electrical current pulling from the power source is limited to 70%. Usually, it
used when a 25A breaker is installed at power source line.
•
If power save function is activated, the maximum performance capacity also dropped to lower level.