Panasonic S-22KA1E5S, Руководство по обслуживанию

Страница: 158 / 335

158
INSERTING THE BATTERIES
•
Remove the battery cover from the infrared remote control, and then insert the two accessory R03 size batteries.
(Be sure not to mistake the polarities.)
•
When inserting the batteries for the first time, or when replacing the batteries, the remote control can not
operating. In such case, use a ballpoint pen or similar object to push the RC RESET switch.
The remote control should then start operating normally.
•
When operating the remote control, if the LCD flickers or if everything lights up, replace the remote control with
new batteries.
11.13.3 ADDRESS SETTING
•
If using a single remote control to operate several air conditioners, be
sure to set the address setting for the remote control and receiver.
•
At the time of shipment from the factory, the address numbers for both
the infrared remote control and the receiver are set to “1.” (When using
only one indoor unit, the indoor unit can be used without changing the
factory default settings.)
REMOTE CONTROL ADDRESS SETTING
Press the address setting switch with a ballpoint pen or similar object to
change the address setting as shown in the illustration to the right.
The address number displayed on the LCD changes in the order:
[ADDRESS 1]
→ [ADDRESS 2] → [ADDRESS 3] → [GROUP] →
[ADDRESS 1] → ... each time this switch is pressed.
LCD
Only the air conditioner unit which address numbers match
the address number on the LCD can be operated.
Note
•
If the batteries are replaced or the remote control is reset, the address setting will return to ADDRESS 1, so you
will need to repeat the address setting. All setting details which are stored in memory will be cleared, so you will
need to repeat the settings.
•
If the address is set to GROUP, more than one indoor unit can be operated at the same time. (Regardless of the
address number of the infrared receiver, the indoor units can be operated with one remote control.)
INFRARED RECEIVER SETTING
1. Press and hold the emergency operation switch for approximately 11 seconds and release it when it beeps 3
times. *Note: It beeps once after 5 seconds and twice after 8 seconds.
2. Press the AC RESET on the remote control.
3. When it is properly set, it beeps once to indicate completion.
4. Check to see if the remote control functions properly or not.