Panasonic PT-VMZ71, Руководство по эксплуатации

Страница: 86 / 167

[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the submenu.
Refer to “Navigating through the menu” (
x
page 62) for the operation of the menu screen.
[STATUS]
Display the status of the projector.
1) Press
as
to select [STATUS].
2) Press the <ENTER> button.
f
The [STATUS] screen is displayed.
3) Press
as
to switch the pages.
f
The page will change each time you press the button.
[SIGNAL]
[NAME] Displays the name of input signal.
[FREQUENCY] Displays the scanning frequency of input signal.
[RUNTIME]
[PROJECTOR] Displays the actual usage time of projector.
[LIGHT RUNTIME] Displays the runtime of the light source.
[CONTINUOUS
LIGHTING TIME]
Displays the elapsed time from when the light source is illuminated.
The elapsed time is reset when the light source is temporarily turned off such as using
the shutter function.
[SERIAL NUMBER] [PROJECTOR] Displays the serial number of the projector.
[VERSION]
[MAIN] Displays the main version of the firmware of the projector.
[SUB] Displays the sub version of the firmware of the projector.
[LD] Displays the version of the light driver of the projector.
Note
f
For the network status, refer to the [NETWORK] menu → [NETWORK STATUS]. (
x
page 103)
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1) Press
as
to select [PROJECTOR ID].
2) Press
qw
to select a projector ID.
f
To select one item among [ALL] and [1] ~ [64].
[ALL] Select when controlling projectors without specifying an ID number.
[1] ~ [64] Select when specifying an ID number to control individual projector.
Note
f
To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f
When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computer
control.
If multiple projectors are set up side by side with ID set to [ALL], you cannot control a projector separately by specifying a different ID
number.
f
Refer to “Setting the ID number on the remote control” (
x
page 60) for how to set the ID number on the remote control.
[INITIAL START UP]
Set the startup method when the projector is switched on after connecting the power plug to outlet .
1) Press
as
to select [INITIAL START UP].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[LAST MEMORY]
Starts up in the status that before removing the power plug from the outlet or turning off the circuit
breaker.
[STANDBY] Starts up in the standby mode.
[ON] Starts the projection immediately.
86 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu